Trumpf Tooling, Forming-Extrusion,Emboss,EKO,Countersink,Louver,Bridge,Centerpoint,Lance and form,Logo stamping
Used in a broad,spectrum of applications,such as selftapping screws,cooling tube holders,airflow applications and tread plate forming tool
Max thickness 3.8mm
Countersink,Coining tool, Pre-Punch need,formingcountersinks and counter bores for screws,or to deburr the edge of a hole.
Material thickness from 1.22 to 6.35mm,dependent upon press tonnage.
Creates marks or emboss in sheet material. It can enhance product value, aid in part marking and eliminate costly secondary operations involved in labeling, painting or otherwise marking parts
*.Popular design for earth symbol mark
*.Formup and formdown
*.Two type, one only mark on signle side. second type emboss type
Scrapless retention system to allow fabricator to
snap punched parts out of sheet metal.
• Material thickness from 0.5 up to 2mm for mild steel and aluminium,and Max 1.5mm for stainless steel.
• Maximum length of form is 36mm
Special design for very small and very slim size,
with several design feature, including:
* Longer support for punch tip by stripper
* Accurate close clearance bewteen punch and guide or stripper.
* Advise punch in TICN coating.
* At least double punch life,reduce punch damaging.
Used to provide air flow or ventilation
Sheet thickness from 0.7 to 2.7mm
Max height 6.5mm top to top
Plug-in units, ventilation slots, spacers, card holders, and cable guides. Can also be used to join sheets together on the front side using sheet metal screws.
Switch cabinet construction, housing construction, cable bushings.
Thickness from 0.7-2.0mm
Max dimater 45mm
Stops, card holders, cable clamps, connection technology, mounting built-in parts, fastening, and tool clamping.
Thickness from 0.5-2.5mm
trumpf lance and form,bracket tool
© 2020 AFAB TOOL LIMITED - All Rights Reserved.
Powered by TENCENT!